Cisco ASR 1013 Hardware Installation Manual page 616

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Removing and Replacing a +24 VDC Power Supply in Cisco ASR 1002 Router

The following figure shows the wire strip and insulation location.

Figure 286: Wire Strip and Lead for the +24 VDC Terminal Block

Using a 3.5mm screwdriver, insert the screwdriver at an angle to release the spring while you install the stripped lead

wire (see the following figure).

Figure 287: Inserting a Screwdriver into the +24 VDC Power Supply Terminal Block

Carefully push the screwdriver at an angle forward until you relieve the spring contact.

With the screwdriver still inserted, gently push the lead wire (ground lead first) in until there is no copper wire showing

as shown in the following figure.

Check that there is no copper portion of the lead wire exposed. Only wire insulation must be visible.

Do not install wire into the terminal block that has not had its insulation removed.

Cisco ASR 1000 Series Router Hardware Installation Guide

Lead wire stripped area

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers

Show Quick Links

Table of Contents

Troubleshooting