Table of Contents
Advertisement
3.
Set the routing parameters in the CPU module 2.
Project window
button
4.
The local station (station number 2) does not require an IP address.
The network address set in the master station (station number 0) is automatically assigned.
5.
Write the set parameters to the CPU module 2. Then reset the CPU module 2 or power off and on
the system.
[Online]
[Write to PLC]
(c) Checking the status of communications
After the setting is completed in each module, execute the IP communication test to check for an error in the
communication route on CC-Link IE Field Network. (
• When the IP communication test is normally completed
The following window appears.
• When the IP communication test ends abnormally
If the test ends abnormally, click the
If IP communications cannot be performed due to a timeout error or other reasons, refer to "IP
communications cannot be performed using the IP packet transfer function" in this manual and take
corrective actions. (
[Parameter]
[Network Parameter]
RESET
or Power OFF
button in "Error Information" to check the error information.
Page 437, Section 12.4.6)
[Ethernet/CC IE/MELSECNET]
ON
Page 156, Section 8.3.3)
CHAPTER 8 FUNCTIONS
165
8
Advertisement
Table of Contents
Troubleshooting
