Table of Contents
Advertisement
(1) Setting data
Setting data
Own station's network No. (1 to 239, 254)
Jn
254: Network specified in Valid Module During Other Station Access
Start I/O number of the master/local module of the own station
(00 to FE
Un
digits)
(S1)
Start device of the own station where control data is stored
(S2)
Start device of the own station where data to be written is stored
Start device of the target station where data is to be written
(D1)
(A continuous area with the write data length is required.)
The device of the own station that turns on for one scan upon
(D2)
completion of the instruction.
If the instruction fails, (D2)+1 also turns on.
Device of the target station, which is turned on for 1 scan upon
(D3)
completion of the instruction.
(Data writing from another station can be confirmed.)
(a) Control data
The control data of the SWRITE instruction control data is the same as that of the WRITE instruction
(
Page 264, Section 10.6)
(b) Start device of the own station where data to be written is stored
The start device of the own station where data to be written by the SWRITE instruction is stored is the same as
that of the WRITE instruction. (
(c) Start device of the target station where data is to be written
The start device of the target station is the same as that of the WRITE instruction. (
10.6)
Description
: Upper two digits of the I/O number expressed in three
H
Page 264, Section 10.6)
CHAPTER 10 DEDICATED INSTRUCTIONS
Set by
Data type
16-bit binary
User
Device name
System
Bit
Page 264, Section
10
277
Advertisement
Table of Contents
Troubleshooting
