Table of Contents
Advertisement
(b) Setting in the local station
Connect GX Works2 to the local station and set parameters.
Master station (station No.0)
1.
Open the network parameter window and set parameters as follows.
Project window
2.
Open the refresh parameter window and set parameters.
Set the same refresh parameters as those set for the master station. (
3.
Select "Hold Input Data (RX/RY)" under "Data Link Faulty Station Setting".
Configure the same setting as that of the master station in "Data Link Faulty Station Setting". (
189, Section 8.8.3 (3))
4.
Write the set parameters to the CPU module on the local station.
[Online]
[Write to PLC]
In this setting example, default settings are used for the parameters other than those described. For the parameter setting,
refer to the chapter explaining the parameters. (
Set parameters.
Local station (station No.1)
[Parameter]
[Network Parameter]
Page 81, CHAPTER 7)
CHAPTER 8 FUNCTIONS
Submaster station (station No.2)
[Ethernet/CC IE/MELSECNET]
Page 189, Section 8.8.3 (3))
8
Page
191
Advertisement
Table of Contents
Troubleshooting
