Table of Contents
Advertisement
(b) Setting in the CPU module 1 and master station 1 (station number 0)
1.
Set the routing parameters to the CPU module 1.
Because the network address is different from that of the request destination device, the Ethernet adapter
module 2 (Ethernet part) does not have a network number. Set the communication route to the network
number 2.
Project window
MELSECNET]
2.
Set the IP address in the master station 1 (station number 0).
Project window
MELSECNET]
3.
Write the set parameters to the CPU module 1. Then reset the CPU module or power off and on the
system.
[Online]
168
[Parameter]
[Network Parameter]
button
[Parameter]
[Network Parameter]
[Write to PLC]
RESET
or Power OFF
[Ethernet/CC IE/
[Ethernet/CC IE/
button
ON
Advertisement
Table of Contents
Troubleshooting
