Table of Contents
Advertisement
• Setting parameters for local stations
Item
Enter the network number.
0
0
Switch 1
Enter the station number.
3
1
Switch 2
Switch 3
Enter "0000
Switch 4
Switch 5
5.
Create a CCPASET instruction program. (
6.
Write PLC parameters and programs to the CPU module through GX Works2.
[Online]
7.
Data link is stopped during in execution. (
If some instruction is executed while data link processing, malfunction may be caused due to a change in
the link device assignment.
8.
Execute the CCPASET instruction.
(2) Parameters that cannot be set using the CCPASET instruction
The following table shows the parameters that cannot be set using the CCPASET instruction. The master/local
module operates with the setting status listed below.
(a) Parameters that cannot be set to the master station and submaster station
Item
Network setting
Mode
Alias
Network Configuration
Comment
Settings
Block Data Assurance per
Station
Network Operation
Parameter Name
Settings
Refresh Parameters
Interrupt Settings
Interlink Transmission Parameters
Routing Parameters
Set the parameters listed above using the network parameters in GX Works2.
Description
H
Network No.: 01
to EF
H
H
Station number: 01
to 78
H
Use the UINI instruction to set the station number.: FF
".
H
[Write to PLC]
Online (Normal Mode)
Not set
Not set
Not set
Not set
Since link refresh cannot be performed, use direct access to directly access the
link device.
Not set (Interrupts cannot be performed.)
Not set (Interlink transmission cannot be performed.)
Not set
Transient transmission that requires routing parameters cannot be performed.
For whether routing parameters are needed, refer to the following.
CHAPTER 10 DEDICATED INSTRUCTIONS
(1 to 239)
H
(1 to 120)
H
H
Page 371, Section 10.17.2 (4))
Page 221, Section 9.4)
Setting status
Page 119, Section 7.8
Setting range
0001
to 00EF
H
H
3101
to 3178
(Station number: 1 to
H
H
120)
31FF
(Set a station number using the
H
UINI instruction.)
0000
(Fixed)
H
10
361
Advertisement
Table of Contents
Troubleshooting
