Table of Contents
Advertisement
(a) Parameters that cannot be set when the master/local module is mounted with a C
Controller module
The following table lists the parameters that cannot be set when the master/local module is mounted with a C
Controller module. The master/local module operates with the setting status listed below.
• Parameters that cannot be set to the master station and submaster station
Network setting
Network Configuration
Settings
Network Operation
Settings
Refresh Parameters
Interrupt Settings
Interlink Transmission Parameters
Routing Parameters
To set the parameters listed above, connect the Universal model QCPU with the master/local module and
configure the settings in the network parameter window of GX Works2.
538
Item
Mode
Alias
Comment
Link Scan Mode Setting
Block Data Assurance per Station
Parameter Name
Setting status
Online (Normal Mode)
Not set
Asynchronous
Not set
Not set
Not set
Since link refresh cannot be performed, directly access the buffer
memory in the master/local module.
Not set (Interrupts cannot be performed.)
Not set (Interlink transmission cannot be performed.)
Not set
Transient transmission that requires routing parameters cannot be
performed.
For whether routing parameters are needed, refer to the following.
Page 119, Section 7.8
Advertisement
Table of Contents
Troubleshooting
