Table of Contents
Advertisement
Item
Selected Station Communication Status
Monitor
button
button
Operation
Test
button
button
button
Information
Confirmation/
button
Set
button
Selected
button
Station
Operation
button
220
Displays the LED status of a module and communication status of PORT1 and
7)
PORT2. (
Page 31, CHAPTER 2)
Displays status of the cables connected to PORT1 and PORT2.
8)
Displays the information of the extension module connected to the remote device
9)
*2
station.
*1
For how to clear the station number set for a slave station in the CC-Link IE
Field Network diagnostics, refer to the manuals for modules used on slave
stations.
*2
To display the information of an extension module, a master/local module
with a serial number (first five digits) of 14102 or later is required.
Performs a communication test. (
Performs an IP communication test. (
Performs a cable test. (
Starts or stops cyclic transmission. (
Displays event history of a network. (
Temporarily cancels a reservation for a slave station or reserves the slave station again.
(
Page 225, Section 9.6)
Sets a slave station as a temporary error invalid station. (
Displays the System Monitor window. (
Performs remote operations (RUN, STOP, and RESET operations) to the CPU module.
(
Page 234, Section 9.8)
Description
: Properly connected
: Error (cable disconnection)
: Error (other than cable disconnection)
Page 79, Section 6.4.3)
Page 156, Section 8.3.3)
Page 78, Section 6.4.2)
Page 221, Section 9.4)
Page 223, Section 9.5)
Page 426, Section 12.2)
Page 229, Section 9.7)
Advertisement
Table of Contents
Troubleshooting
