-48 Vdc Power System Output For Cisco Asr 1002 Router; Cisco Asr 1002 Router +24 Vdc Power Supply - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Cisco ASR 1000 Series Routers Component Overview

common input ranges for reference only. The –48 VDC power input connector is a Euro-style terminal block

that accepts three wires, one positive, one negative, and one grounding wire.

Table 27: Cisco ASR 1002 Router – 48 VDC Power System Input

Voltage Range (VDC)

International

–48 VDC Power System Output for Cisco ASR 1002 Router

The –48 VDC power supply output tolerance is defined in the following table under all combinations of –48

VDC input line variation. Total system power consumption should not exceed 470 watts or output rating of

each power supply.

Two power supplies are used for redundant operation. System total power consumption shall never exceed

rating of one power supply to maintain redundancy.

Table 28: Cisco ASR 1002 Router – 48 VDC Power System Output Voltage and Current

Output Voltage

Output Current

This section provides information about the +24 VDC power supplies on the rear of the Cisco ASR 1002

Router. The recommended branch circuit breaker for the Cisco ASR 1002 Router +24 VDC power supply is

a 40 A UL listed circuit breaker.

The Cisco ASR 1002 Router has two of the same type power supplies in power supply slot 0 and power supply

slot 1. The power supply slot identifiers are zero (0) on the left side of the chassis rear and one (1) on the right

side of the chassis rear. The power supply switch is a standby switch and is not considered a disconnect.

Cisco ASR 1000 Series Router Hardware Installation Guide

Cisco ASR 1002 Router +24 VDC Power Supply

Show Quick Links

Table of Contents

Troubleshooting