Power Supplies In The Cisco Asr 1002-F Router; Ac Power Supply For The Cisco Asr 1002-F Router - Cisco ASR 1013 Hardware Installation Manual

Asr 1000 series

Hide thumbs Also See for ASR 1013:

Table of Contents

Cisco ASR 1002-F Router Overview and Installation

Power Supplies in the Cisco ASR 1002-F Router

The Cisco ASR 1002-F Router power supply consists of either an AC or DC input in a closed frame power

supply with two DC voltage outputs: 12 V and 3.3 V. The AC power supply operates between 85 VAC to

264 VAC and the DC power supply operates between –40.5 VDC to –72 VDC.

The power supplies are installed into the rear of the chassis and are hot pluggable. The Cisco ASR 1002-F

Router supports up to 588 W of input power from an infrastructure standpoint, but the initial power supply

development limit is up to 470 W of output power (AC and DC input).

The AC power supply input inlet is an IEC connector with an AC switch and the current rating on the connector

and switch is 10 A. The AC power supply is secured into the chassis with two captive installation screws

mounted on the faceplate.

The following table describes the LEDs on the Cisco ASR 1002-F Router.

Table 63: Cisco ASR 1002-F Router AC Power Supply LEDs

Power supply activity

Power supply fan activity

A bi-color LED indicates fan

Power Supplies in the Cisco ASR 1002-F Router

Cisco ASR 1000 Series Router Hardware Installation Guide

The AC input voltage is greater

If the LED is not illuminated,

then either the input voltage is

less than 70V, or the power

supply is turned off.

If the AC input voltage is

between 70V and 85V, the

INPUT OK LED can be on, off,

or flashing.

All fans are operational.

A fan failure is detected.

Show Quick Links

Table of Contents