hit counter script

Siemens SINUMERIK 840D sl Function Manual page 1651

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

DB31, ...
DBW136
Analog measured value: Of the clamping system
Edge evaluation: No
Sensor S1 supplies an analog voltage value: 0 - 10 V. The analog value of the clamped state is
mapped to: 0 - 10000 increments, resolution 1 mV
Note
SIMATIC S7 input module: 0 - 27648 increments, resolution 0.36 mV
Adaptation factor if you change to a spindle with SMI 24: 2,7648
Corresponding to ...
DB31, ... DBW134 (clamped state)
Drive parameters: p5041[0...5], p5043[0...6]
DB31, ...
DBX138.4
Sensor S4, piston end position
Edge evaluation: No
Signal state 1
The piston is in position, i.e. the piston is free to move
Signal state 0
The piston is not in position
Corresponding to ...
DB31, ... DBX132.4 (Sensor S4 available)
DB31, ...
DBX138.5
Sensor S5, angular position of the motor shaft
Edge evaluation: No
Signal state 1
The motor shaft is in position (requirement: The spindle is stationary)
Signal state 0
The motor shaft is not aligned
Corresponding to ...
DB31, ... DBX132.5 (sensor S5 available)
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Signal(s) updated: Cyclically
Signal(s) updated: Cyclically
Signal(s) updated: Cyclically
Z1: NC/PLC interface signals
19.11 Spindles (S1)
1651

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828dSinumerik 840de sl

Table of Contents

Save PDF