hit counter script

Siemens SINUMERIK 840D sl Function Manual page 1408

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

W1: Tool offset
18.5 Tool radius compensation 2D (TRC)
Figure 18-14 Approach and retraction with constant curvature during inside machining of a full circle:
KONTT and KONTC compared
The figure below shows the differences in approach/retraction behavior between KONTT and
KONTC. A circle with a radius of 20 mm about the center point at X0 Y-40 is compensated with
a tool with an external radius of 20 mm. The tool center point therefore moves along a circular
path with radius 40 mm. The end point of the approach blocks is at X40 Y30. The transition
between the circular block and the retraction block is at the zero point. Due to the extended
continuity of curvature associated with KONTC, the retraction block first executes a movement
with a negative Y component. This will often be undesired. This response does not occur with
the KONTT retraction block. However, with this block, an acceleration step change occurs at
the block transition.
If the KONTT or KONTC block is the approach block rather than the retraction block, the contour
is exactly the same, but is simply machined in the opposite direction, i.e. the approach and
retraction behavior are symmetrical.
1408
3D representation.
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828dSinumerik 840de sl

Table of Contents

Save PDF