Signals From Nc (Db10); Plc Basic Program (P3) - Siemens SINUMERIK 840D sl Function Manual
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
DB10
DBX56.2
Acknowledge emergency stop
Special cases,
The emergency stop state cannot be reset using the interface signal:
errors, ......
DB21, ... DBX7.7 (reset).
Corresponding to ...
DB10 DBX56.1 (Emergency stop)
DB10 DBX106.1 (emergency stop active)
DB11 DBX0.7 (mode group reset)
19.8.2
Signals from NC (DB10)
DB10
DBX106.1
Emergency stop active
Edge evaluation: No
Signal state 1 or
The NC is in the emergency stop state.
edge change
0 → 1
Corresponding to ...
DB10 DBX56.1 (Emergency stop)
DB10 DBX56.2 (acknowledge emergency stop)
19.9
PLC basic program (P3)
To describe the NC/PLC interface signals, refer to:
References:
Functions Manual, Basic Functions; PLC Basic Program (P3)
Chapter: "Signal/Data Specifications"
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Signal(s) updated: Cyclically
Z1: NC/PLC interface signals
19.9 PLC basic program (P3)
1631
Advertisement
Table of Contents
