Tool Parameter 2: Cutting Edge Position - Siemens SINUMERIK 840D sl Function Manual
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Figure 18-3
The width of the saw blade is accounted for with tool radius compensation (G40 to G42 as
follows:
Com‐
mand
G40
G41
G42
18.4.3
Tool parameter 2: Cutting edge position
Description
The cutting edge position describes the position of the tool tip P in relation to the cutting edge
center point S. It is entered in tool parameter 2.
The cutting edge position is required together with the cutting edge radius (tool parameter 8)
for the calculation of the tool radius compensation for turning tools (tool type 5xx).
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Geometry of slotting saw (analogous to angle head cutter)
Significance
No saw blade compensation
Saw blade compensation left
Saw blade compensation right
W1: Tool offset
18.4 Tool cutting edge
1393
Advertisement
Table of Contents
