hit counter script

Signals From Axis/Spindle (Db31 - Siemens SINUMERIK 840D sl Function Manual

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

DB31, ...
DBX3.1
Enable travel to fixed stop
Edge evaluation: no
Signal state 1 or
Meaning when FXS function is selected using the part program
edge change
(IS "Activate travel to fixed stop" = 1):
0 → 1
→ Travel to fixed stop is enabled and the axis traverses from the start position at the programmed
velocity to the programmed target position.
Signal state 0
Meaning when FXS function is selected using the part program
(IS "Activate travel to fixed stop" = 1):
→ Travel to fixed stop is inhibited.
→ The axis is stationary at the start position with reduced torque.
→ The channel message "wait": Auxiliary function acknowledgment missing" is displayed.
Edge change
1 → 0
Meaning before the fixed stop has been reached
(IS "fixed stop reached" = 0):
→ Travel to fixed stop is aborted.
→ The alarm "20094: Axis%1 Function aborted" is displayed.
Meaning after the fixed stop has been reached
IS "fixed stop reached" = 1):
→ The torque limiting and monitoring of the fixed stop monitoring window are canceled.
Deselection: DB31, ...DBX1.1 (acknowledge fixed stop reached)
IS irrelevant
MD37060 $MA_FIXED_STOP_ACKN_MASK
for ...
(monitoring PLC acknowledgments for travel to fixed stop)
= 0 or 2
Corresponding to ....
MD37060 $MA_FIXED_STOP_ACKN_MASK
(monitoring PLC acknowledgments for travel to fixed stop)
DB31, ... DBX62.4 (activate travel to fixed stop)
19.4.2

Signals from axis/spindle (DB31, ...)

DB31, ...
DBX62.4
Activate travel to fixed stop
Edge evaluation: no
Signal state 1 or
The "Travel to fixed stop" function is active.
edge change
This signal is used for analog drives in order, for example, to activate the current or torque limitation
0 → 1
parameterized in the actuator.
Signal state 0 or
The "Travel to fixed stop function" is not active.
edge change
1 → 0
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Signal(s) updated: cyclic
Signal(s) updated: cyclic
Z1: NC/PLC interface signals
19.4 Travel to fixed stop (F1)
1595

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828dSinumerik 840de sl

Table of Contents

Save PDF