DB31, ...
DBX2.2
Delete distance-to-go (axis-specific) / spindle reset
Special cases,
"Delete distance-to-go (axis-specific)"
errors, ....
After the axes have been stopped with "Delete distance-to-go" the next program block is prepared
with the new positions. The axes thus follow a different contour to the one originally defined in the
part program after a "Delete distance-to-go".
If G90 is programmed in the block after "Delete distance-to-go" it is at least possible to approach the
programmed absolute position. On the other hand, with G91, the position originally defined in the part
program is no longer reached in the following block.
Corresponding to ...
DB21, ... DBX6.2 (delete distance-to-go, channel-specific)
Additional references Function Manual, Basic Functions; Spindles (S1)
DB31, ...
DBX9.0 - DBX9.2
Position controller parameter set selection A, B, C
Edge evaluation: No
Meaning
Six different position controller parameter sets can be selected with the interface signals A, B, and
C. The following assignment applies:
Signal irrelevant
MD35590 $MA_PARAMSET_CHANGE_ENABLE = 0
for ...
Corresponding to ...
DB31, ...DBX69.0, .1, ..2 (feedback: Active position controller parameter set)
Additional references CNC Commissioning Manual: NCK, PLC, Drive, Section "Commissioning NCK" >
Edge evaluation: No
DB31, ...
DBX9.3
Parameter set switchover commands from NC disabled
Edge evaluation: No
Signal state 1
The parameter set switchover is disabled.
Signal state 0
The parameter set switchover is enabled.
Corresponding to ...
DB31, ... DBX9.0, .1, .2
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Signal(s) updated: On request
Parameter set
1
2
3
4
5
6
6
6
Signal(s) updated: On request
Signal(s) updated: On request
Z1: NC/PLC interface signals
19.1 Various interface signals and functions (A2)
C
0
0
0
0
1
1
1
1
B
A
0
0
0
1
1
0
1
1
0
0
0
1
1
0
1
1
1575