hit counter script

Siemens SINUMERIK 840D sl Function Manual page 1617

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

DB21, ...
DBX33.5
M02/M30 active
Application exam‐
The PLC can detect the end of program processing with this signal and react appropriately.
ple(s)
Special cases,
● The M02 and M30 functions have equal priority.
errors, ......
● The interface signal:
● Not suitable for automatic follow-on functions such as workpiece counting, bar feed, etc. For these
● Auxiliary functions that could result in a read-in operation being stopped and any S values that
DB21, ...
DBX33.6
Transformation active
Edge evaluation: No
Signal state 1
The NC command TRAORI (activate transformation) is programmed in the NC part program. This
block has been processed by the NC and the transformation is now activated.
Signal state 0
No transformation active.
Additional references Programming Manual, Job Planning
DB21, ...
DBX33.7
Program test active
Edge evaluation: No
Signal state 1
Program control program test is active. Axis disable is set internally for all axes (not spindles). There‐
fore the machine axes do not move when a part program block or a part program is being processed.
The axis movements are simulated on the user interface with changing axis position values.
The axis position values for the display are generated from the calculated setpoints.
The part program is processed in the normal way.
Signal state 0
Program control "Program test" is not active.
Corresponding to ...
DB21, ... DBX1.7 (activate program test)
DB21, ... DBX25.7 (program test selected)
DB21, ...
DBX35.0
Program status running
Edge evaluation: No
Signal state 1
The part program was started with the interface signal:
DB21, ... DBX7.1 (NC Start)
and is running.
The running program was stopped with the interface signal:
DB21, ... DBX6.1 (read-in disable)
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
19.6 Mode group, channel, program operation, reset response (K1)
DB21, ... DBX33.5 (M02/M30 active)
is available as steady-state signal after the end of the program.
functions, M02/M30 must be written in a separate block and the word M02/M30 or the decoded M
signal used.
are to be operative beyond M02/M30 must not be written in the last block of a program.
Signal(s) updated: Cyclically
Signal(s) updated: Cyclically
Signal(s) updated: Cyclically
Z1: NC/PLC interface signals
1617

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828dSinumerik 840de sl

Table of Contents

Save PDF