hit counter script

Siemens SINUMERIK 840D sl Function Manual page 1214

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

S1: Spindles
16.2 Modes
The spindle rotates at the programmed spindle speed whereby the speed is lower than the
configured position-control activation speed:
MD35300 $MA_SPIND_POSCTRL_VELO
The spindle is synchronized.
Phase 2
Spindle speed > Position-control activation speed
When the SPOS, M19 or SPOSA command is activated, the spindle begins to slow down to the
position-control activation speed with the configured acceleration:
MD35200 $MA_GEAR_STEP_SPEEDCTL_ACCEL
The spindle is synchronized once the encoder limit frequency threshold is crossed.
Spindle speed < Position-control activation speed
SPOS, M19 or SPOSA are programmed to switch the spindle to position control mode (if it is not
already in that mode).
The configured acceleration in position control mode is activated:
MD35210 $MA_GEAR_STEP_POSCTRL_ACCEL
The travel path to the target point is calculated.
The spindle travels to the programmed end point optimally in terms of time. This means that
the end point is approached at the highest possible speed (maximum MD35300
$MA_SPIND_POSCTRL_VELO). Depending on the appropriate secondary conditions, phases
2 - 3 - 4 - 5 or 4a - 5a are executed.
Phase 3
Spindle speed > Position-control activation speed
When the configured position-control activation speed
(MD35300 $MA_SPIND_POSCTRL_VELO) is reached:
● Position control is activated (if not already active).
● The distancetogo (to the target point) is calculated.
● There is a switch to the configured configured acceleration in position control mode (or this
acceleration is retained):
MD35210 $MA_GEAR_STEP_POSCTRL_ACCEL
Spindle speed < Position-control activation speed
The spindle was accelerated up to the configured position-control activation speed (MD35300
$MA_SPIND_POSCTRL_VELO) to reach the end point. This is not exceeded.
The braking start point calculation detects when the programmed spindle position can be
approached accurately at the acceleration configured in position control mode (MD35210
$MA_GEAR_STEP_POSCTRL_ACCEL).
1214
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828dSinumerik 840de sl

Table of Contents

Save PDF