hit counter script

Siemens Moore 353 User Manual page 216

Process automation controller
Table of Contents

Advertisement

Installation
To install or
remove cover:
squeeze
both sides
~1/16"
to clear
alignment
tabs.
FIGURE 8-1 Direct Entry Connectors, Cover Installation and Removal
Installation
1. Align the removable portion of the connector with the fixed portion.
2. Press the removable portion onto the fixed portion.
3. Tighten the two captive screws. Do not over tighten. Check that wires and components remain connected
securely.
4. Install the cover as shown in the above figure.
COVER AND CONNECTOR REMOVAL AND INSTALLATION, SIDE ENTRY
Removal:
1. Remove the connector cover by slightly compressing the cover's U-shaped extrusion to free the cover's tabs.
The cover may be secured by two screws, as described below. The cover is shown in Figure 8-5.
2. As necessary, disconnect, unclamp, or unbundle wires connected to the connector to be removed. Be sure there
is sufficient slack in the wiring for connector removal.
3. Grasp the connector tab and pull straight out from the case. A slight bias on the pull toward the center of the
Connector Socket will often ease removal. See Figure 8-3. Be careful not to stress or damage connected wires
and components.
8-4
To Install Terminal Cover:
1. Orient the cover as shown. Note the four hooked
tabs and Ethernet cable clearance cutout.
2. Squeeze the cover slightly at the two small cutouts
in the cover edges and fully insert the four hooked
cover tabs in the rear panel slots.
3. Allow cover sides to relax. Pull the cover straight
down until it snaps into place. The cutouts in the
cover edges will engage two alignment tabs on
the rear panel.
Where needed, the Ethernet cable should exit
through the large cutout in the cover.
To Remove Cover:
1. Squeeze the cover slightly at the two cutouts
in the cover edges (about 2" down from the
top of the cover) and push cover upward.
2. Pull cover out from rear panel.
Ethernet cable cutout.
UM353-1
March 2003

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents