UM353-1
14.10.2 Special Conditions for Safe Use
Always refer to the labels on the controller case for approvals and certifications applicable to that instrument.
FM
Enclosure Requirements:
•
The apparatus must be mounted within an enclosure or assembly to prevent personal injury resulting from
accessibility to live parts. The enclosure is typically user-supplied and, therefore, was not examined as part of
this Approval but shall comply with the requirements of this section.
•
Accessibility - The system must be installed within the enclosure so that its circuits are accessible by the use of
a tool only. A part is accessible when either a.) the IEC articulate accessibility probe applied in every possible
position to the exterior or exposed surfaces, including the bottom; or b.) the IEC rigid accessibility probe
applied with a maximum force of 30 Newtons (6.75 lbs force) in every possible position to the exterior or
exposed surface, including the bottom, touches the part.
•
Protection from Fire - If the enclosure is non-metallic, it shall have the proper flammability rating.
•
Grounding - A metallic enclosure must have a protective grounding terminal and be marked as such. All
accessible non-current conductive parts must be bonded to the protective grounding terminal.
•
General Construction - The equipment enclosure, or parts of the enclosure, required to be in place to comply
with the requirements for protection from electric shock, personal injury, protection of internal parts and wiring
and external cord and cable assembly strain relief shall comply with the following tests for mechanical strength:
•
Impact Tests - The equipment shall be held firmly against a rigid support and shall be subjected to sets of
three blows with 6.6 Joules (4.9 pound force-inch) from a spring-operated impact hammer. The hammer
shall be applied to any external part that when broken is likely to expose live parts. A window of an
indicating device shall withstand an impact of 0.085 Newton-meter (0.753 pound force-inch) from a
hollow steel impact sphere 50.8 mm (2 inches) in diameter and an approximate mass of 113.4 grams (4
ounces).
•
Pressure Tests - A force of 90 Newtons (20 pounds) shall be applied from a metal rod 12.7 mm (0.50 inch)
in diameter, the end of which is rounded. The force shall be applied for one minute to any point on the
overall enclosure except the bottom. The bottom shall sustain a force of 65 Newtons (15 pounds).
•
Tip Stability Test - Equipment having a weight of 11 kilograms (24 pounds) or more shall not tip over
when placed at the center of an inclined plane that makes an angle of 10 degrees with the horizontal and
then turned to the position (with all doors, drawers, and other openable and sliding parts in the least stable
position) most likely to cause tip-over.
•
Sharp Edges - An accessible edge, projection, or corner of an enclosure, opening, frame, guard, handle, or
the like shall be smooth and well rounded, and shall not cause a cut-type injury during normal use of the
equipment.
CE
•
Use of the equipment in a manner not specified by the manufacturer may impair the protection provided by the
equipment.
•
Route electrical power to the station through a clearly labeled circuit breaker or on-off switch that is located
near the station and is accessible by the operator. The breaker or switch should be located in a non-explosive
atmosphere unless suitable for use in an explosive atmosphere.
•
Local Instrument Link twinaxial cable must be shielded.
•
The next page contains a Declaration of Conformance with the standards or other normative documents stated
on the certificate.
•
Environmental Conditions, Per IEC 664, Installation Category II, Pollution Degree 2
•
A representative unit was tested in accordance with EN50082-2. Test results are available upon request.
March 2003
Model Designation and Specifications
14-13