Siemens SIMATIC S7-1200 System Manual page 1273

Hide thumbs Also See for SIMATIC S7-1200:

Table of Contents

Table 13- 148 Data types for the parameters

Parameter and type

S7-1200 Programmable controller

System Manual, V4.2, 09/2016, A5E02486680-AK

13.9 Legacy Modbus RTU communication (CM/CB 1241 only)

0=No request

1= Request to transmit data to Modbus slave

Modbus RTU station address:

Standard addressing range (1 to 247)

Extended addressing range (1 to 65535)

The value of 0 is reserved for broadcasting a message to all Modbus

slaves. Modbus function codes 05, 06, 15 and 16 are the only function

codes supported for broadcast.

Mode Selection: Specifies the type of request (read, write, or diagnostic).

See the Modbus functions table below for details.

Starting Address in the slave: Specifies the starting address of the data to

be accessed in the Modbus slave. See the Modbus functions table below

for valid addresses.

Data Length: Specifies the number of bits or words to be accessed in this

request. See the Modbus functions table below for valid lengths.

Data Pointer: Points to the M or DB address (non-optimized DB type) for

the data being written or read.

The DONE bit is TRUE for one scan, after the last request was completed

with no error.

0 – No MB_MASTER operation in progress

1 – MB_MASTER operation in progress

The ERROR bit is TRUE for one scan, after the last request was termi-

nated with an error. The error code value at the STATUS parameter is

valid only during the single scan where ERROR = TRUE.

Execution condition code

Communication processor and Modbus TCP