Hw-Module - Cisco Catalyst 3560-X Command Reference Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Software configuration manual (1538 pages) ,
- Command reference manual (1244 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
hw-module
hw-module
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Catalyst 3750-X and 3560-X Switch Command Reference
2-206
Downloaded from
www.Manualslib.com
Use the hw-module global configuration command on the switch stack or on a standalone switch to
enable on-board failure logging (OBFL). Use the no form of this command to disable this feature.
hw-module module [switch-number] logging onboard [message level level]
no hw-module module [switch-number] logging onboard [message level]
switch-number
(Optional) On Catalyst 3750-X switches, specify the switch number, which is the
stack member number. If the switch is a standalone switch, the switch number is 1.
If the switch is in a stack, the range is 1 to 9, depending on the switch member
numbers in the stack.
On Catalyst 3560-X switches, the switch number is always 1.
message level
(Optional) Specify the severity of the hardware-related messages that are stored in
level
the flash memory. The range is from 1 to 7.
OBFL is enabled, and all messages appear.
Global configuration
Release
Modification
12.2(53)SE2
This command was introduced.
We recommend that you keep OBFL enabled and do not erase the data stored in the flash memory.
To ensure that the time stamps in the OBFL data logs are accurate, you should manually set the system
clock, or configure it by using Network Time Protocol (NTP).
If you do not enter the message level level parameter, all the hardware-related messages generated by
the switch are stored in the flash memory.
On a standalone switch, entering the hw-module module [switch-number] logging onboard [message
level level] command is the same as entering the hw-module module logging onboard [message level
level] command.
Entering the hw-module module logging onboard [message level level] on a stack master enables
OBFL on all the stack members that support OBFL.
In a switch stack, if you enter the hw-module module [switch-number] logging onboard command on
a stack member that does not support OBFL, such as a Catalyst 3750 switch, a message appears with that
information. If a Catalyst 3750 switch is a stack master in a mixed stack of Catalyst 3750-E or
Catalyst 3750-X and 3750 switches and you enter an OBFL command on the Catalyst 3750 switch, the
command does not take affect on the stack master, but the stack master sends the OBFL configuration to
the stack members.
manuals search engine
Chapter 2
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
OL-21522-02
Advertisement
Table of Contents
