Location (Interface Configuration) - Cisco Catalyst 3560-X Command Reference Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Software configuration manual (1538 pages) ,
- Command reference manual (1244 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
location (interface configuration)
location (interface configuration)
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
Catalyst 3750-X and 3560-X Switch Command Reference
2-328
Downloaded from
www.Manualslib.com
Use the location interface command to enter location information for an interface. Use the no form of
this command to remove the interface location information.
location {additional-location-information word | civic-location-id id | elin-location-id id}
no location {additional-location-information word | civic-location-id id | elin-location-id id}
additional-location-information
word
civic-location-id
elin-location-id
id
This command has no default setting.
Interface configuration
Release
Modification
12.2(53)SE2
This command was introduced.
After entering the location civic-location-id id interface configuration command, you enter civic
location configuration mode. In this mode, you can enter the additional location information.
The civic location identifier must not exceed 250 bytes.
These examples show how to enter civic location information for an interface:
Switch(config-if)# interface gigabitethernet1/0/1
Switch(config-if)# location civic-location-id 1
Switch(config-if)# end
Switch(config-if)# interface gigabitethernet2/0/1
Switch(config-if)# location civic-location-id 1
Switch(config-if)# end
manuals search engine
Chapter 2
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Configure additional information for a location or place.
Specify a word or phrase that provides additional location
information.
Configure global civic location information for an interface.
Configure emergency location information for an interface.
Specify the ID for the civic location or the elin location. The ID
range is 1 to 4095.
The identifier for the civic location in the LLDP-MED
Note
TLV is limited to 250 bytes or less. To avoid error
messages about available buffer space during switch
configuration, be sure that the total length of all
civic-location information specified for each
civic-location ID does not exceed 250 bytes.
OL-21522-02
Advertisement
Table of Contents
