Cisco Catalyst 3560-X Command Reference Manual page 527

Hide thumbs Also See for Catalyst 3560-X:

Table of Contents

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands

Related Commands

Downloaded from

www.Manualslib.com

If you use the no service password-recovery command to control end user access to passwords, we

recommend that you save a copy of the config file in a location away from the switch in case the end user

uses the password recovery procedure and sets the system back to default values. Do not keep a backup

copy of the config file on the switch.

If the switch is operating in VTP transparent mode, we recommend that you also save a copy of the

vlan.dat file in a location away from the switch.

When you enter the service password-recovery or no service password-recovery command on the

stack master, it is propagated throughout the stack and applied to all switches in the stack.

You can verify if password recovery is enabled or disabled by entering the show version privileged

EXEC command.

This example shows how to disable password recovery on a switch or switch stack so that a user can only

reset a password by agreeing to return to the default configuration.

Switch(config)# no service-password recovery

Switch(config)# exit

show version

manuals search engine

Displays version information for the hardware and firmware.

Catalyst 3750-X and 3560-X Switch Command Reference

service password-recovery

Catalyst 3750-x