Table of Contents
Advertisement
7. GasLab Q2 Displays (Operate the Device)
GasLab Q2 will begin its starting procedure after the power supply has been connected and it has
been switched on. After this starting procedure has been completed, the device will provide an
overview of the state of the measurement on the screen. Both LED's above the screen also called
display, will be permanently lit. There is no need to exit this screen for normal analysis mode. GasLab
Q2 continuously displays new measurements here; the values for partly saturated gas will be
shown.
Some functions and operating modes (known as operations) do require the use of other displays,
or the use of the enSuite configuration and analysis software.
Therefore, two types of access to the instrument are possible:
1.
via the operation panel local on the device (described in this chapter)
via a PC or laptop with the
2.
(described in Chapter 8)
For each type of access applies:
•
The device has a user management system protected by a password to
protect important settings and simplify the parameterization process.
There are no passwords when the device is supplied!
•
Only one user can be logged in at any one time.
Your own password can be created and edited at any time on the device.
•
Changes which have been completed but not yet saved are discarded when
you log out. Logins, logouts and password changes are entered into the
device's logbook.
to make the measuring equipment easier for you to use and for using all the
Information for general use
Rev. M / 73023639
GASLAB Q2 DISPLAYS (OPERATE THE DEVICE)
Access methods
Configuration and analysis software enSuite
Honeywell can provide classes and training
individual options offered by the device.
If you are interested, please contact Honeywell.
The
data
can be found at the beginning of this document.
Contact
87
GasLab Q2
Advertisement
Table of Contents
