Cisco 7604 Configuration Manual page 385
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Chapter 25
Configuring IPv4 Multicast VPN Support
Configuring the Route-Target Extended Community
To configure the route-target extended community, perform this task:
Command or Action
Step 1
Router(config-vrf)# route-target [import |
export | both] route_target_ext_community
Router(config-vrf)# no route-target [[import |
export | both] route_target_ext_community ]
Step 2
Router(config-vrf)# do show ip vrf detail
When configuring the route-target extended community, note the following information:
•
•
•
•
This example shows how to configure 55:1111 as the import and export route-target extended
community and verify the configuration:
Router(config-vrf)# route-target both 55:1111
Router(config-vrf)# do show ip vrf detail
VRF blue; default RD 55:1111; default VPNID <not set>
VRF Table ID = 1
No interfaces
Connected addresses are not in global routing table
Export VPN route-target communities
Import VPN route-target communities
No import route-map
No export route-map
CSC is not configured.
Configuring the Default MDT
To configure the default MDT, perform this task:
Command or Action
Router(config-vrf)# mdt default group_address
Router(config-vrf)# no mdt default
OL-4266-08
import—Imports routing information from the target VPN extended community.
export—Exports routing information to the target VPN extended community.
both—Imports and exports.
route_target_ext_community—Adds the 48-bit route-target extended community to the VRF. Enter
the number in one of the following formats:
16-bit AS number:your 32-bit number (101:3)
–
32-bit IPv4 address:your 16-bit number (192.168.122.15:1)
–
RT:55:1111
RT:55:1111
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Purpose
Configures a route-target extended community for the VRF.
Deletes the route-target extended community.
Verifies the configuration.
Purpose
Configures the default MDT.
Deletes the default MDT.
Configuring MVPN
25-11
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
