Configuring Vlan Acls; Understanding Vacls - Cisco 7604 Configuration Manual
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Configuring VLAN ACLs
This chapter describes how to configure VLAN ACLs (VACLs) on Cisco 7600 series routers.
Note
•
•
•
This chapter consists of these sections:
•
•
•
For additional information (including configuration examples and troubleshooting information), see the
Tip
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Understanding VACLs
These sections describe VACLs:
•
•
•
•
OL-4266-08
For complete syntax and usage information for the commands used in this chapter, refer to the Cisco
IOS Master Command List, Release 12.2SX at this URL:
http://www.cisco.com/en/US/docs/ios/mcl/122sxmcl/12_2sx_mcl_book.html
With a Supervisor Engine 720 and releases earlier than Release 12.2(17d)SXB, VACL capture is
supported only for use with the WS-SVC-IDSM2-K9 Intrusion Detection System Module 2 and the
WS-SVC-NAM-2 and WS-SVC-NAM-1 network analysis modules. This restriction is removed in
Release 12.2(17d)SXB and later releases.
OAL and VACL capture are incompatible. Do not configure both features on the router. With OAL
configured (see the
"Optimized ACL Logging with a PFC3" section on page
capture traffic.
Understanding VACLs, page 35-1
Configuring VACLs, page 35-4
Configuring VACL Logging, page 35-11
VACL Overview, page 35-2
Bridged Packets, page 35-2
Routed Packets, page 35-3
Multicast Packets, page 35-4
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
C H A P T E R
34-5), use SPAN to
35
35-1
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
