Show L2Protocol-Tunnel - Cisco ME 3400 Command Reference Manual
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (872 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
show l2protocol-tunnel
show l2protocol-tunnel
Use the show l2protocol-tunnel user EXEC command to display information about Layer 2 protocol
tunnel ports. Displays information for interfaces with protocol tunneling enabled.
This command is available only if your switch is running the metro IP access or metro access image.
Syntax Description
interface interface-id
summary
| begin
| exclude
| include
expression
Command Modes
User EXEC
Command History
Release
12.2(25)EX
Usage Guidelines
After enabling Layer 2 protocol tunneling on an access port, a trunk port, or an IEEE 802.1Q tunnel port
by using the l2protocol-tunnel interface configuration command, you can configure some or all of these
parameters:
•
•
•
If you enter the show l2protocol-tunnel [interface interface-id] command, only information about the
active ports on which all the parameters are configured appears.
If you enter the show l2protocol-tunnel summary command, only information about the active ports
on which some or all of the parameters are configured appears.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Cisco ME 3400 Ethernet Access Switch Command Reference
2-498
show l2protocol-tunnel [interface interface-id] [summary] [ | {begin | exclude | include}
expression]
(Optional) Specify the interface for which protocol tunneling information
appears. Valid interfaces are physical ports and port channels; the port
channel range is 1 to 64.
(Optional) Display only Layer 2 protocol summary information.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Protocol type to be tunneled
Shutdown threshold
Drop threshold
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-10
Advertisement
Table of Contents
