Cisco ME 3400 Command Reference Manual page 630
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (872 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
snmp-server enable traps
pim
[invalid-pim-message |
neighbor-change |
rp-mapping-change]
port-security
[trap-rate value]
rtr
snmp [authentication |
coldstart | linkdown |
linkup | warmstart]
storm-control
trap-rate value
stpx [inconsistency]
[root-inconsistency]
[loop-inconsistency]
syslog
transceiver all
tty
vlan-membership
vlancreate
vlandelete
Though visible in the command-line help strings, the fru-ctrl insertion and removal, and vtp keywords
Note
are not supported. The snmp-server enable informs global configuration command is not supported. To
enable the sending of SNMP inform notifications, use the snmp-server enable traps global
configuration command combined with the snmp-server host host-addr informs global configuration
command.
Cisco ME 3400 Ethernet Access Switch Command Reference
2-602
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
(Optional) Enable Protocol-Independent Multicast (PIM) traps. The
keywords have these meanings:
invalid-pim-message—(Optional) Enable invalid PIM message traps.
•
neighbor-change—(Optional) Enable PIM neighbor-change traps.
•
rp-mapping-change—(Optional) Enable rendezvous point
•
(RP)-mapping change traps.
(Optional) Enable port security traps. Use the trap-rate keyword to set the
maximum number of port-security traps sent per second. The range is from
0 to 1000; the default is 0 (no limit imposed; a trap is sent at every
port-security occurrence).
(Optional) Enable SNMP Response Time Reporter traps.
(Optional) Enable SNMP traps. The keywords have these meanings:
authentication—(Optional) Enable authentication trap.
•
coldstart—(Optional) Enable cold-start trap.
•
linkdown—(Optional) Enable linkdown trap.
•
linkup—(Optional) Enable linkup trap.
•
•
warmstart—(Optional) Enable warm-start trap.
(Optional) Enable storm-control traps. Use the trap-rate keyword to set the
maximum number of storm-control traps sent per minute. The range is from
0 to 1000; the default is 0 (no limit is imposed; a trap is sent at every
storm-control occurrence).
(Optional) Enable SNMP STPX MIB traps. The keywords have these
meanings:
inconsistency—(Optional) Enable SNMP STPX MIB inconsistency
•
update traps.
root-inconsistency—(Optional) Enable SNMP STPX MIB root
•
inconsistency update traps.
loop-inconsistency—(Optional) Enable SNMP STPX MIB loop
•
inconsistency update traps.
(Optional) Enable SNMP syslog traps.
(Optional) Enable SNMP traps for all supported Digital Optical Monitoring
(DoM)-capable transceivers installed on the switch.
(Optional) Send TCP connection traps. This is enabled by default.
(Optional) Enable SNMP VLAN membership traps.
(Optional) Enable SNMP VLAN-created traps.
(Optional) Enable SNMP VLAN-deleted traps.
OL-9640-10
Advertisement
Table of Contents
