Cisco ME 3400 Command Reference Manual page 143

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

For information about the ethernet lmi interface configuration command, see the Cisco IOS Carrier

Ethernet Command Reference at this URL:

http://www.cisco.com/en/US/docs/ios/cether/command/reference/ce_book.html

To enable the switch as an Ethernet LMI CE device, you must enter both the ethernet lmi global and

ethernet lmi ce commands. By default Ethernet LMI is disabled, and, when enabled the switch is in

provider-edge mode unless you also enter the ethernet lmi ce command.

When the switch is configured as an Ethernet LMI CE device, these interface configuration commands

and keywords are visible, but not supported:

This example shows how to configure the switch as an Ethernet LMI CE device:

Switch(config)# ethernet lmi global

Switch(config)# ethernet lmi ce

Related Commands

ethernet lmi interface

configuration command

service instance

ethernet uni

ethernet lmi t392

Enables Ethernet LMI for a user-network interface.

Cisco ME 3400 Ethernet Access Switch Command Reference

ethernet lmi