Cisco ME 3400 Command Reference Manual page 313

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

To configure speed or duplex settings on a dual-purpose port, you must first select the media type. If you

configure auto-select, you cannot configure the speed and duplex interface configuration commands.

When you change the interface type, the speed and duplex configurations are removed. The switch

configures both types to autonegotiate speed and duplex (the default).

When the media type ia auto-select, the switch uses these criteria to select the media type:

This example shows how to select the SFP interface:

Switch(config)# interface gigabitethernet0/1

Switch(config-if)# media-type sfp

You can verify your setting by entering the show interfaces interface-id capabilities or the show

interfaces interface-id transceiver properties privileged EXEC commands.

Related Commands

show interfaces

capabilities

show interfaces

transceiver properties

An SFP is not installed until it has a fiber or copper cable plugged into the SFP module.

If only one media type is installed, that interface is active and remains active until the media is

removed or the switch is reloaded.

If you install both media types in a dual-purpose port that is enabled, the switch selects the active

link based on which type is installed first.

When the switch powers on with both cables connected, or when you enable a dual-purpose port

through the shutdown and the no shutdown interface configuration commands, the switch gives

preference to the SFP module interface. In all other situations, the switch selects the active link

based on the type that first links up.

Displays the capabilities of all interfaces or the specified interface.

Displays speed, duplex, and media-type settings on all interfaces or the

specified interface.

Cisco ME 3400 Ethernet Access Switch Command Reference