Show Interfaces Rep - Cisco ME 3400 Command Reference Manual
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (872 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
show interfaces rep
show interfaces rep
Use the show interfaces rep User EXEC command to display Resilient Ethernet Protocol (REP)
configuration and status for a specified interface or for all interfaces.
Syntax Description
interface-id
detail
| begin
| exclude
| include
expression
Command Modes
User EXEC
Command History
Release
12.2(40)SE
Usage Guidelines
In the output for the show interface rep [detail] command, in addition to an Open, Fail, or AP (alternate
port) state, the Port Role might show as Fail Logical Open (FailLogOpen) or Fail No Ext Neighbor
(FailNoNbr). These states indicate that the port is physically up, but REP is not configured on the
neighboring port. In this case, one port goes into a forwarding state for the data path to help maintain
connectivity during configuration. The Port Role for this port shows as Fail Logical Open; the port
forwards all data traffic on all VLANs. The other failed Port Role shows as Fail No Ext Neighbor; this
port blocks traffic for all VLANs.
When the external neighbors for the failed ports are configured, the failed ports go through the alternate
port state transitions and eventually go to an Open state or remain as the alternate port, based on the
alternate port election mechanism.
In the show interfaces rep command output, ports configured as edge no-neighbors are designated with
an asterisk (*) in front of Primary Edge or Secondary Edge. In the output of the show interfaces rep
detail command, No-Neighbor is spelled out.
The output of this command is also included in the show tech-support privileged EXEC command
output.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Cisco ME 3400 Ethernet Access Switch Command Reference
2-452
show interfaces [interface-id] rep [detail] [ | {begin | exclude | include} expression]
(Optional) Display REP configuration and status for a specified physical interface or
port channel ID.
(Optional) Display detailed REP configuration and status information.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-10
Advertisement
Table of Contents
