Debug Etherchannel - Cisco ME 3400 Command Reference Manual

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

debug etherchannel

Use the debug etherchannel privileged EXEC command to enable debugging of the

EtherChannel/PAgP shim. This shim is the software module that is the interface between the Port

Aggregation Protocol (PAgP) software module and the port manager software module. Use the no form

of this command to disable debugging.

PAgP is available only on network node interfaces (NNIs) or enhanced network interfaces (ENIs).

Syntax Description

Though visible in the command-line help strings, the linecard keyword is not supported.

Debugging is disabled.

Command Modes

Privileged EXEC

Command History

Usage Guidelines

If you do not specify a keyword, all debug messages appear.

The undebug etherchannel command is the same as the no debug etherchannel command.

Related Commands

show debugging

show etherchannel

Cisco ME 3400 Ethernet Access Switch Command Reference

debug etherchannel [all | detail | error | event | idb]

no debug etherchannel [all | detail | error | event | idb]

(Optional) Display all EtherChannel debug messages.

(Optional) Display detailed EtherChannel debug messages.

(Optional) Display EtherChannel error debug messages.

(Optional) Debug major EtherChannel event messages.

(Optional) Display PAgP interface descriptor block debug messages.

Modification

This command was introduced.

Displays information about the types of debugging that are enabled.

Displays EtherChannel information for the channel.

Cisco ME 3400 Ethernet Access Switch Debug Commands