Snmp Trap Mac-Notification Change - Cisco ME 3400 Command Reference Manual

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

snmp trap mac-notification change

Use the snmp trap mac-notification change interface configuration command to enable the Simple

Network Management Protocol (SNMP) MAC address notification trap on a specific Layer 2 interface.

Use the no form of this command to return to the default setting.

Syntax Description

By default, the traps for both address addition and address removal are disabled.

Command Modes

Interface configuration

Command History

Usage Guidelines

Even though you enable the notification trap for a specific interface by using the snmp trap

mac-notification command, the trap is generated only when you enable the snmp-server enable traps

mac-notification and the mac address-table notification global configuration commands.

This example shows how to enable the MAC notification trap when a MAC address is added to a port:

Switch(config)# interface gigabitethernet0/2

Switch(config-if)# snmp trap mac-notification change added

You can verify your settings by entering the show mac address-table notification change interface

privileged EXEC command.

Cisco ME 3400 Ethernet Access Switch Command Reference

snmp trap mac-notification change {added | removed}

no snmp trap mac-notification change {added | removed}

Enable the MAC notification trap whenever a MAC address is added on this

Enable the MAC notification trap whenever a MAC address is removed from this

Modification

This command was introduced.

The change keyword was added.

Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands