Cisco ME 3400 Command Reference Manual page 156

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

interface port-channel

Follow these guidelines when you use the interface port-channel command:

For a complete list of configuration guidelines, see the "Configuring EtherChannels" chapter in the

software configuration guide for this release.

This example shows how to create a port-channel interface with a port channel number of 5:

Switch(config)# interface port-channel 5

You can verify your setting by entering the show running-config privileged EXEC or show

etherchannel channel-group-number detail privileged EXEC command.

Related Commands

channel-group

show etherchannel

show running-config

Cisco ME 3400 Ethernet Access Switch Command Reference

If you want to use the Cisco Discovery Protocol (CDP), you must configure it only on the physical

port and not on the port-channel interface.

CDP is available only on network node interfaces (NNIs) and enhanced network interfaces

Do not configure a port that is an active member of an EtherChannel as an IEEE 802.1x port. If IEEE

802.1x is enabled on a not-yet active port of an EtherChannel, the port does not join the

EtherChannel.

Assigns an Ethernet port to an EtherChannel group.

Displays EtherChannel information for a channel.

Displays the operating configuration. For syntax information, use this link

to the Cisco IOS Release 12.2 Command Reference listing page:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command

_reference_list.html

Select the Cisco IOS Commands Master List, Release 12.2 to navigate to

the command.

Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands