Table of Contents
Advertisement
MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1019(PR)】 dia Diameter specification axis
Select the command method of program travel amount.
When the travel amount is commanded with the diameter dimensions, the travel distance will be
5mm when the command is 10mm of travel distance.
The travel amount per pulse will also be halved during manual pulse feed.
If diameter is selected, tool length, the wear compensation amount, and the workpiece coordinate
offset will be displayed in diameter value. Other parameters concerning length will always be
displayed in radius value.
0: Command with travel amount
1: Command with diameter dimension
【#1020(PR)】 sp_ax Spindle Interpolation
Select "1" when using the spindle for the contour control of NC axis (C-axis).
0: Servo axis is used for contour control.
1: Spindle is used for contour control.
【#1021(PR)】 mcp_no Drive unit I/F channel No. (servo)
Using a 4-digit number, set the drive unit interface channel No. and which axis in that channel is to
be used when connecting a servo drive unit.
【#1022(PR)】 axname2 2nd axis name
Set the name of the axis displayed on the screen with two characters. (X1, Z2, etc.)
Always use an alphabetic character (A to Z) for the first character.
---Setting range---
A to Z and 1 to 9 (Two digits)
(Setting will be cleared when "0" is set)
【#1023(PR)】 crsadr Command address during mixed control (cross axis control)
Set the axis name for issuing a command to this axis during mixed control (cross axis control).
---Setting range---
A to Z
(Setting will be cleared when "0" is set)
【#1024(PR)】 crsinc Incremental command address during mixed control (cross axis
control)
Set the axis name for issuing an incremental command to this axis during mixed control (cross axis
control).
---Setting range---
A to Z
(Setting will be cleared when "0" is set)
【#1025】 l_plane Initial plane selection
Select the plane to be selected when the power is turned ON or reset.
0: X-Y plane (G17 command state)
1: X-Y plane (G17 command state)
2: Z-X plane (G18 command state)
3: Y-Z plane (G19 command state)
222
Axis No.
Not used Set to "0"
Drive unit interface channel No.
- Quick Links:
- Device Configuration
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
