Table of Contents
Advertisement
【#1229】 set01
bit0: Subprogram interrupt
Select the type of the user macro interrupt.
0: Macro type user macro interrupt
1: Sub-program type user macro interrupt
bit1: Accurate thread cutting E
Select what the address E specifies in inch screw cutting.
0: Number of threads per inch
1: Precision lead
bit2: Radius compensation type B (for M system only)
Select the method of the arithmetic processing for the intersection point when the start-up or cancel
command is operated during radius compensation.
0: The processing does not handle the start-up or cancel command block: handle the offset vector
1: The processing is executed for the intersection point between the command block and the next
bit2: Nose R compensation type B (for L system only)
Select the method of the arithmetic processing for the intersection point when the start-up or cancel
commands are operated during nose R or radius compensation.
0: The processing does not handle the start-up or cancel command block: handle the offset vector
1: The processing is executed for the intersection point between the command block and the next
bit3: Initial constant surface speed
Select the initial state after the power-ON.
0: Constant surface speed control cancel mode
1: Constant surface speed control mode
bit4: Synchronous tap
Select the operation when ",R" is omitted in G74/G84 tapping cycle.
0: Asynchronous tap
1: Synchronous tap
bit5: Start point alarm
Select the operation when the operation start point cannot be found while executing the next block of
G117.
0: Enables the auxiliary function after the block has been executed.
1: Outputs the program error (P33).
bit6: Grid display selection
Select the grid display type on the servo monitor screen during the dog type reference position
return.
0: Distance between dog OFF and basic point (including a grid mask amount)
1: A value given by reducing a grid mask amount from the distance between dog OFF and basic
【#1230】 set02
bit7: Macro interface input/output for each part system
Select the specification of the macro interface input/output.
0: Shared by all part systems.
1: Used independently by the part systems.
in the direction vertical to that of the command instead.
block.
in the direction vertical to that of the command instead.
block.
point
M700VS Series Setup Manual
Appendix 1.2 Base Specifications Parameters
251
- Quick Links:
- Device Configuration
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
