Table of Contents
Advertisement
P370 No spec: Facing t-post MR
Details
The facing turret mirror image specifications are not provided.
Remedy
- Check the specifications.
P371 Facing t-post MR illegal
Details
- Mirror image for facing tool posts was commanded to an axis in external mirror image or parameter
mirror image.
- The commanded mirror image for facing tool posts enables the mirror image for a rotary axis.
Remedy
- Correct the program.
- Correct the parameter settings.
P380 No spec: Corner R/C
Details
The corner R/C was issued though it is out of specifications.
Remedy
- Check the specifications.
- Delete the corner chamfering/corner rounding command in the program.
P381 No spec: Arc R/C
Details
Corner chamfering II or corner rounding II was commanded in the arc interpolation block though it is
out of specifications.
Remedy
- Check the specifications.
P382 No corner movement
Details
The block next to corner chamfering/ corner rounding is not a travel command.
Remedy
- Replace the block succeeding the corner chamfering/ corner rounding command by G01 command.
P383 Corner movement short
Details
The travel distance in the corner chamfering/corner rounding command was shorter than the value in
the corner chamfering/corner rounding command.
Remedy
- Set the smaller value for the corner chamfering/corner rounding than the travel distance.
P384 Corner next movement short
Details
The travel distance in the following block in the corner chamfering/corner rounding command was
shorter than the value in the corner chamfering/corner rounding command.
Remedy
- Set the smaller value for the corner chamfering/corner rounding than the travel distance in the
following block.
P385 Corner during G00/G33
Details
A block with corner chamfering/corner rounding was given during G00 or G33 modal.
Remedy
- Correct the program.
M700VS Series Setup Manual
Appendix 2.12 Program Errors (P)
593
- Quick Links:
- Device Configuration
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
