Table of Contents
Advertisement
【#7910】 SLCT_INT_MODE Interpolation method selection
Select the interpolation method.
0: Joint interpolation method
1: Single axis rotation interpolation method
【#7911】 SLCT_STANDARD_POS Rotary axis basic position selection
Select the basic position of the rotary axis.
0: Workpiece coordinate zero point
1: The position when the tool center point is commanded.
(Note) Even if the position is changed, it is not changed during tool center point control. It is changed
【#7912】 NO_MANUAL Selection of manual feed for 5-axis machining
Select whether to enable the manual feed for 5-axis machining.
0: Enable (manual feed for 5-axis machining)
1: Disable (standard manual feed)
【#7913】 MCHN_SPEED_CTRL Machine speed fluctuation suppression
Select whether to suppress the machine speed fluctuation due to rotary axis movement.
0: Not suppress
1: Suppress
(Note)This parameter is disabled when SSS control is enabled.
【#7914】 ROT_PREFILT Rotary axis prefilter time constant
Set the time constant for rotary axis prefilter.
Setting this parameter can smoothen the tool angle change (rotary axis' motion) under tool center
point control.
When set to "0", "Rotary axis prefiltering" will be disabled.
---Setting range---
0 to 200 (ms)
【#7915】 SLCT_SLOPE_CRD_MOD Rotary axis basic position in inclined surface machining
Set the basic position of rotary axis to establish the feature coordinate system when inclined surface
machining is commanded.
* The position will not change when inclined surface machining is running. It will change when the
next inclined surface machining is commanded.
0: At zero degree
1: At the start position
【#7920(PR)】 SLCT_T1 Rotary axis selection
Select in which axis direction to rotate the tool rotating type base-side rotary axis.
If the tool axis is inclined, use the second digit to set the axis direction in which the tool axis is
inclined.
0: Invalid
1: I axis rotation
2: J axis rotation
3: K axis rotation
(Note) 0 to 99 can be set from the screen, but if an invalid value is set, the operation error "M01 0127
---Setting range---
0 to 3
12, 13, 21, 23, 31, 32
when next tool center point control will be commanded.
Rot axis parameter error" will occur when the power supply is turned ON.
M700VS Series Setup Manual
Appendix 1.6 Rotary Axis Configuration Parameters
409
- Quick Links:
- Device Configuration
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
