hit counter script

Mitsubishi Electric M700VS Series Setup Manual page 29

Mitsubishi cnc
Table of Contents

Advertisement

MITSUBISHI CNC
2 Connecting and Setting the Hardware
(c) When using one power supply shared unit by two NC communication bus systems
In systems employing a number of small-capacity drive units, a single power supply unit can be shared by two
NC communication bus systems. In this case, a power supply control axis must be set for each axis of each
NC communication bus.
For basic connection information, refer to the MDS-DM Series Instruction Manual.
Connected to the NC
(1st part system)
Optical
communication
cable
Connected to the NC
(2nd part system)
Optical
communication
cable
Connections when using one power supply shared by two NC communication bus systems
If the two NC communication bus systems include a spindle drive unit, connect the power
supply unit's CN4 connector to the CN4 connector of the largest capacity spindle drive unit. If
CAUTION
there is no spindle drive unit, connect to the unbalance-axis servo drive unit.
12
MDS-D-V2
MDS-D-V2
1st/2nd axis
3rd/4
th axis
MDS-DM-V3
MDS-D-SP
8th/9th/10th axis
11th axis
MDS-DM-V3
5th/6th/7th axis
(CV control axis)
CN4
MDS-D-SP
MDS-D-CV
12th axis
(Shared)
(CV control axis)
CN4
CN4
CN9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents