Ips Netsim Max-Bandwidth-Mbps - Cisco MDS 9000 series Command Reference Manual

Hide thumbs Also See for MDS 9000 series:

Table of Contents

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ips netsim max-bandwidth-mbps

To limit the bandwidth in megabytes per second of a specified Gigabit Ethernet interface, use the ips

netsim max-bandwidth-mbps command in SAN extension tuner configuration submode.

Syntax Description

max-bandwidth-mbps

gigabitethernet

Command Modes

SAN extension tuner configuration submode.

Command History

Usage Guidelines

To use this command, you must enable the IP Network Simulator using the ips netsim enable command.

The following example shows how to limit the interface bandwidth to 45 Mbps.

switch# config terminal

switch(config)#

switch(config)# san-ext-tuner enable

switch(config)# exit

switch# ips netsim max-bandwidth-mbps 45 ingress gigabitethernet 2/3

Related Commands

show ips netsim

ips netsim enable

OL-8413-07, Cisco MDS SAN-OS Release 3.x

ips netsim max-bandwidth-mbps bandwidth ingress gigabitethernet slot/port

Specifies the bandwidth in megabytes per second. The range is 1 to 1000.

Specifies the ingress direction.

Specifies the the slot and port number of the Gigabit Ethernet interface.

Modification

This command was introduced.

Displays a summary of the interfaces that are currently operating in network

simulation mode.

Enables the IP Network Simulator.

ips netsim max-bandwidth-mbps

Cisco MDS 9000 Family Command Reference