Logging Level - Cisco MDS 9000 series Command Reference Manual
Hide thumbs
Also See for MDS 9000 series:
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages) ,
- Hardware installation manual (60 pages)
Table of Contents
Advertisement
logging level
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
logging level
To modify message logging facilities, use the logging level command. To negate the previously issued
command or to revert to factory defaults, use the no form of the command.
Syntax Description
facility-name
severity-level
Defaults
Disabled
Command Modes
Configuration mode.
Command History
Release
1.3(1)
Usage Guidelines
The switch logs messages at or above the configured severity level.
Examples
Configures Telnet or SSH logging for the kernel facility at level 4 (warning). As a result, logging
messages with a severity level of 4 or above will be displayed.
switch# config terminal
switch(config)# logging level kernel 4
Related Commands
Command
show logging
Cisco MDS 9000 Family Command Reference
14-16
logging level facility-name severity-level
no logging level facility-name severity-level
Specifies the required facility name (for example acl, or ivr, or port, etc.)
Specifies the maximum severity of messages logged. The range is 0 to 7,
where 0 is emergency, 1 is alert, 2 is critical, 3 is error, 4 is warning, 5 is
notify, 6 is informational, and 7 is debugging.
Modification
This command was introduced.
Description
Displays logging configuration information.
Chapter 14
L Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Advertisement
Table of Contents
