Member (Zoneset Configuration Submode) - Cisco MDS 9000 series Command Reference Manual
Hide thumbs
Also See for MDS 9000 series:
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages) ,
- Hardware installation manual (60 pages)
Table of Contents
Advertisement
member (zoneset configuration submode)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
member (zoneset configuration submode)
To configure zone set zone members, use the member command in zone set configuration submode. To
remove a zone set member, use the no form of the command.
Syntax Description
member-name
Defaults
None.
Command Modes
Zone set configuration submode.
Command History
Release
1.0(2)
Usage Guidelines
None.
Examples
The following example shows how to add a member zone to a zone set.
switch# config terminal
switch(config)# zoneset name Zoneset1 vsan 10
switch(config-zoneset)# member ZoneA
Related Commands
Command
show zone
zoneset name
Cisco MDS 9000 Family Command Reference
15-12
member member-name
no member member-name
Specifies the member name. Maximum length is 64 characters.
Modification
This command was introduced.
Description
Displays zone information.
Creates a zone set.
Chapter 15
M Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Advertisement
Table of Contents
