Qos Control Priority - Cisco MDS 9000 series Command Reference Manual
Hide thumbs
Also See for MDS 9000 series:
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages) ,
- Hardware installation manual (60 pages)
Table of Contents
Advertisement
Chapter 19
Q Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
qos control priority
To enable the QoS priority assignment for control traffic feature on the Cisco MDS 9000 family of
switches, use the qos control command in configuration mode. To revert to the factory default, use the
no form of the command.
Syntax Description
0
Defaults
Enabled and priority 7 are the defaults.
Command Modes
Configuration mode.
Command History
Release
1.0(2)
Usage Guidelines
None.
Examples
The following example sets the QoS priority assignment to the highest level.
switch# config terminal
switch(config)# no qos control priority 0
Related Commands
Command
show qos
OL-8413-07, Cisco MDS SAN-OS Release 3.x
qos control priority 0
no qos priority control 0
Specifies the lowest priority. To revert to the highest priority, use the no form
of the command.
Modification
This command was introduced.
Description
Displays configured QoS information.
Cisco MDS 9000 Family Command Reference
qos control priority
19-3
Advertisement
Table of Contents
