Default Voice Vlan Configuration; Voice Vlan Configuration Guidelines - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 15
Configuring Voice VLAN
Untagged traffic from the device attached to the Cisco IP Phone passes through the phone unchanged,
Note
regardless of the trust state of the access port on the phone.
Configuring Voice VLAN
•
•
•
Default Voice VLAN Configuration
The voice VLAN feature is disabled by default.
When the voice VLAN feature is enabled, all untagged traffic is sent according to the default CoS
priority of the port.
The CoS value is not trusted for IEEE 802.1p or IEEE 802.1Q tagged traffic.
Voice VLAN Configuration Guidelines
These are the voice VLAN configuration guidelines:
•
Note
•
•
•
•
•
OL-26520-01
Default Voice VLAN Configuration, page 15-3
Voice VLAN Configuration Guidelines, page 15-3
Configuring a Port Connected to a Cisco 7960 IP Phone, page 15-4
Voice VLAN configuration is only supported on switch access ports; voice VLAN configuration is
not supported on trunk ports.
Trunk ports can carry any number of voice VLANs, similar to regular VLANs. The configuration of
voice VLANs is not required on trunk ports.
The voice VLAN should be present and active on the switch for the IP phone to correctly
communicate on the voice VLAN. Use the show vlan privileged EXEC command to see if the
VLAN is present (listed in the display). If the VLAN is not listed, see
VLANs,"
for information on how to create the voice VLAN.
The Power over Ethernet (PoE) switches are capable of automatically providing power to Cisco
pre-standard and IEEE 802.3af-compliant powered devices if they are not being powered by an AC
power source. For information about PoE interfaces, see the
Mode on a PoE Port" section on page
Before you enable voice VLAN, we recommend that you enable QoS on the switch by entering the
mls qos global configuration command and configure the port trust state to trust by entering the mls
qos trust cos interface configuration command. If you use the auto-QoS feature, these settings are
automatically configured. For more information, see
You must enable CDP on the switch port connected to the Cisco IP Phone to send the configuration
to the phone. (CDP is globally enabled by default on all switch interfaces.)
The Port Fast feature is automatically enabled when voice VLAN is configured. When you disable
voice VLAN, the Port Fast feature is not automatically disabled.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
"Configuring a Power Management
12-33.
Chapter 33, "Configuring QoS."
Configuring Voice VLAN
Chapter 13, "Configuring
15-3
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
