Searching And Filtering Output Of Show And More Commands; Accessing The Cli - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 2
Using the Command-Line Interface
The software assumes you have a terminal screen that is 80 columns wide. If you have a width other than
that, use the terminal width privileged EXEC command to set the width of your terminal.
Use line wrapping with the command history feature to recall and modify previous complex command
entries. For information about recalling previous command entries, see the
Keystrokes" section on page
Searching and Filtering Output of show and more Commands
You can search and filter the output for show and more commands. This is useful when you need to sort
through large amounts of output or if you want to exclude output that you do not need to see. Using these
commands is optional.
To use this functionality, enter a show or more command followed by the pipe character (|), one of the
keywords begin, include, or exclude, and an expression that you want to search for or filter out:
command | {begin | include | exclude} regular-expression
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output appear.
This example shows how to include in the output display only lines where the expression protocol
appears:
Switch# show interfaces | include protocol
Vlan1 is up, line protocol is up
Vlan10 is up, line protocol is down
Accessing the CLI
You can access the CLI through a console connection, through Telnet, or by using the browser.
You manage the switch stack and the stack member interfaces through the stack master. You cannot
manage stack members on an individual switch basis. You can connect to the stack master through the
console port of one or more stack members. Be careful with using multiple CLI sessions to the stack
master. Commands you enter in one session are not displayed in the other sessions. Therefore, it is
possible to lose track of the session from which you entered commands.
Stacking is supported only on Catalyst 2960-S switches running the LAN base image.
Note
We recommend using one CLI session when managing the switch stack.
Note
If you want to configure a specific stack member port, you must include the stack member number in the
CLI command interface notation. For more information about interface notations, see the
Interface Configuration Mode" section on page
To debug a specific stack member, you can access it from the stack master by using the session
stack-member-number privileged EXEC command. The stack member number is appended to the system
prompt. For example,
the system prompt for the stack master is
a CLI session to a specific stack member.
OL-26520-01
2-7.
is the prompt in privileged EXEC mode for stack member 2, and where
Switch-2#
Switch
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Searching and Filtering Output of show and more Commands
12-16.
. Only the show and debug commands are available in
"Editing Commands through
"Using
2-9
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
