Displaying Ipv6 Acls - Cisco Catalyst 2960 Software Configuration Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Displaying IPv6 ACLs

You can display information about all configured access lists, all IPv6 access lists, or a specific access

list by using one or more of the privileged EXEC commands in

Commands for Displaying IPv6 Access List Information

show access-lists

show ipv6 access-list [access-list-name]

This is an example of the output from the show access-lists privileged EXEC command. The output

shows all access lists that are configured on the switch.

Switch #show access-lists

Extended IP access list hello

IPv6 access list ipv6

This is an example of the output from the show ipv6 access-lists privileged EXEC command. The output

shows only IPv6 access lists configured on the switch.

Switch# show ipv6 access-list

IPv6 access list inbound

IPv6 access list outbound

Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE

10 permit ip any any

permit ipv6 any any sequence 10

permit tcp any any eq bgp (8 matches) sequence 10

permit tcp any any eq telnet (15 matches) sequence 20

permit udp any any sequence 30

deny udp any any sequence 10

deny tcp any any eq telnet sequence 20

Display all access lists configured on the switch.

Display all configured IPv6 access list or the access list specified by

Configuring IPv6 ACLs

Show Quick Links

Table of Contents

Catalyst 2960-s