Cisco Catalyst 2960 Software Configuration Manual page 746
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Understanding QoS
Classification Based on QoS ACLs
If the switch is running the LAN Lite image, you can configure ACLs, but you cannot attach them to
Note
physical interfaces. You can attach them to VLAN interfaces to filter traffic to the CPU.
You can use IP standard, IP extended, or Layer 2 MAC ACLs to define a group of packets with the same
characteristics (class). In the QoS context, the permit and deny actions in the access control entries
(ACEs) have different meanings than with security ACLs:
•
•
•
•
When creating an access list, remember that, by default, the end of the access list contains an implicit
Note
deny statement for everything if it did not find a match before reaching the end.
After a traffic class has been defined with the ACL, you can attach a policy to it. A policy might contain
multiple classes with actions specified for each one of them. A policy might include commands to
classify the class as a particular aggregate (for example, assign a DSCP) or rate-limit the class. This
policy is then attached to a particular port on which it becomes effective.
You implement IP ACLs to classify IP traffic by using the access-list global configuration command;
you implement Layer 2 MAC ACLs to classify non-IP traffic by using the mac access-list extended
global configuration command. For configuration information, see the
section on page
Classification Based on Class Maps and Policy Maps
To use policy maps, the switch must be running the LAN Base image.
Note
A class map is a mechanism that you use to name a specific traffic flow (or class) and to isolate it from
all other traffic. The class map defines the criteria used to match against a specific traffic flow to further
classify it. The criteria can include matching the access group defined by the ACL or matching a specific
list of DSCP or IP precedence values. If you have more than one type of traffic that you want to classify,
you can create another class map and use a different name. After a packet is matched against the
class-map criteria, you further classify it through the use of a policy map.
A policy map specifies which traffic class to act on. Actions can include trusting the CoS, DSCP, or IP
precedence values in the traffic class; setting a specific DSCP or IP precedence value in the traffic class;
or specifying the traffic bandwidth limitations and the action to take when the traffic is out of profile.
Before a policy map can be effective, you must attach it to a port.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
33-8
If a match with a permit action is encountered (first-match principle), the specified QoS-related
action is taken.
If a match with a deny action is encountered, the ACL being processed is skipped, and the next ACL
is processed.
If no match with a permit action is encountered and all the ACEs have been examined, no QoS
processing occurs on the packet, and the switch offers best-effort service to the packet.
If multiple ACLs are configured on a port, the lookup stops after the packet matches the first ACL
with a permit action, and QoS processing begins.
33-49.
Chapter 33
Configuring QoS
"Configuring a QoS Policy"
OL-26520-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
