Cisco Catalyst 2960 Software Configuration Manual page 203
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 7
Managing Switch Stacks
Setting the Member Priority Value
This task is available only from the master.
Note
Beginning in privileged EXEC mode, follow these steps to assign a priority value to a member: This
procedure is optional.
Command
Step 1
configure terminal
Step 2
switch stack-member-number priority
new-priority-number
Step 3
end
Step 4
reload slot stack-member-number
Step 5
show switch stack-member-number
Step 6
copy running-config startup-config
You can also set the SWITCH_PRIORITY environment variable. For more information, see the
"Controlling Environment Variables" section on page
Provisioning a New Member for a Stack
Note
This task is available only from the master.
Beginning in privileged EXEC mode, follow these steps to provision a new member for a stack. This
procedure is optional.
Command
Step 1
show switch
Step 2
configure terminal
Step 3
switch stack-member-number provision
type
Step 4
end
Step 5
show running-config
OL-26520-01
Purpose
Enter global configuration mode.
Specify the member number and the new priority for the member. The
member number range is 1 to 4. The priority value range is 1 to 15.
You can display the current priority value by using the show switch user
EXEC command.
The new priority value takes effect immediately but does not affect the
current master until the current master or the stack resets.
Return to privileged EXEC mode.
Reset the member, and apply this configuration.
Verify the member priority value.
(Optional) Save your entries in the configuration file.
Purpose
Display summary information about the stack.
Enter global configuration mode.
Specify the member number for the provisioned switch. By default, no
switches are provisioned.
For stack-member-number, the range is 1 to 4. Enter a member number
that is not already used in the stack. See Step 1.
For type, enter the model number of the member.
Return to privileged EXEC mode.
Verify the correct numbering of interfaces in the configuration.
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Configuring the Switch Stack
3-21.
7-21
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
