Configuring The Ethernet Management Port; Tftp And The Ethernet Management Port - Cisco Catalyst 2960 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Command reference manual (800 pages) ,
- Hardware installation manual (108 pages)
Table of Contents
Advertisement
Chapter 12
Configuring Interface Characteristics
•
•
•
•
Before enabling a feature on the Ethernet management port, make sure that the feature is supported. If
Caution
you try to configure an unsupported feature on the Ethernet Management port, the feature might not work
properly, and the switch might fail.
Configuring the Ethernet Management Port
To specify the Ethernet management port in the CLI, enter fastethernet0.
To disable the port, use the shutdown interface configuration command. To enable the port, use the no
shutdown interface configuration command.
To find out the link status to the PC, you can monitor the LED for the Ethernet management port. The
LED is green (on) when the link is active, and the LED is off when the link is down. The LED is amber
when there is a POST failure.
To display the link status, use the show interfaces fastethernet 0 privileged EXEC command.
TFTP and the Ethernet Management Port
Use the commands in
loader.
Table 12-3
Command
arp [ip_address]
mgmt_clr
mgmt_init
mgmt_show
ping host_ip_address
OL-26520-01
Interface features
Speed—10 Mb/s, 100 Mb/s, and autonegotiation
–
Duplex mode—Full, half, and autonegotiation
–
Loopback detection
–
Cisco Discovery Protocol (CDP)
DHCP relay agent
IPv4 and IPv6 access control lists (ACLs)
Table 12-3
Boot Loader Commands
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
Using the Ethernet Management Port (Catalyst 2960-S Only)
when using TFTP to download or upload a configuration file to the boot
Description
Displays the currently cached ARP
without the ip_address parameter.
Enables ARP to associate a MAC address with the specified IP address
when this command is entered with the ip_address parameter.
Clears the statistics for the Ethernet management port.
Starts the Ethernet management port.
Displays the statistics for the Ethernet management port.
Sends ICMP ECHO_REQUEST packets to the specified network host.
1
table when this command is entered
12-25
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
